THIS REMOTE IS DISCONTINUED BUT WE DO HAVE A REPLACEMENT AVAILABLE THAT WORKS. THE ANDERIC RRU401.5 UNIVERSAL.
Code 5319 is guaranteed to work for the CHANNEL MASTER CM7500XRC2 Remote Control
Programming Instructions
1. Turn on the Channel master
2. Press and hold the mode key (e.g., STB) you wish to program for about 3 seconds until the mode light remains on, release the mode key.
3. Input the 4-digit code 5319
? If valid - Mode key light will go out directly;
? If invalid - Mode key will blink three times quickly and go out, please try inputting the code again.
4. Check to see if most of the keys work to the control your device, if not, please try the next code under the same brand & repeat all steps.
Note: During the programming mode, not pressing any button for 20 seconds will cause remote to exit programming mode.

For a full set of operating instructions please refer to the operating manual. If you do not have the manual, you may click on your model from remotes shown below.

NOTE: RRU401 Will not do Macros for powering on or off the Channel master. (Original unit has two power buttons and our remote will not tolerate it.)
Originally supplied with models: CM7001, CM7004, CM7500TB1, CM7500XRC2